YuGiOh Playmat
por Mitchell F en Thangs
This play-mat is designed for use with or without approved card sleeves.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a Mitchell F.
Archivos (9)
- counter.stl STL · 187 KB
- axel.stl STL · 30 KB
- Extra Deck + Terrain Zone.stl STL · 44 KB
- Card + Graveyard.stl STL · 59 KB
- Pin.stl STL · 12 KB
- Magic Area.stl STL · 88 KB
- Magic Area Right.stl STL · 76 KB
- Magic Area Left.stl STL · 75 KB
- Deck Area.stl STL · 91 KB
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 74
- Publicado
Sobre este modelo
This play-mat is designed for use with or without approved card sleeves. - The Extra Deck is set to handle 15 Cards - The Main Deck is set to handle 50 Cards - The Graveyard is set to handle 40 Cards
This is designed for use with the classic rules however will look to add in the additional summon zones for single summons at a later date (Since I play classic).
Each STL has the details of how to print.
I printed these using Draft (.3) and 10% infill for the main parts while the Pins and Axel at 50%.
The left and Right Magic Areas have a single hole to link up to required side component i.e. Card Deck or Terrain.
When putting together I used needle nose pliers to hold the pins and a rubber mallet to tap into the holes.
Ensure you together the Card and Magic ares first then put all together .
Descripción original del autor, publicada en Thangs.
