X-Shot Spinshot Silly Shell Frontend
por ProJec_ en Printables
A frontend that allows the Spinshot to take Silly Shells
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a ProJec_.
Archivos (4)
- Categoría
- Juguetes y juegos
- Formatos
- 3MF, STL
- Descargas
- 19
- Publicado
Sobre este modelo
Introduction: I wanted to have the Spinshot become a backup shotgun of sorts, so I decided to make this. I would NOT recommend yanking the front up, as the shell would just eject itself. You will need to remove the rotating block that cycles the cylinder.
Gemeneye's X-Shot Stock Point is needed for the hammer. Print everything as normal except for the hammer. Updates: 10/11: Updated 3MF to include everything needed to print. Updated the hammer so that the front end will not fall down if you try to quickly draw it. I have also found that the front end will sometimes drop after firing. It doesn't affect performance, but it can be an issue.
Descripción original del autor, publicada en Printables.
