Wavy Springo
Another amazing Springo printed without supports using regular old PLA! This Springo has a smooth wavy surface that can come off as fun or classy, depending on your color choice.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Devin B.
Archivos (1)
- wavyspringo.stl STL · 3,5 MB
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 431
- Publicado
Sobre este modelo
Another amazing Springo printed without supports using regular old PLA! This Springo has a smooth wavy surface that can come off as fun or classy, depending on your color choice.
Print at .15mm layer height for this to work correctly. Check the layers in your slicer, there should be a 1-2 layer gap between each layer of the spring. I print with 3 shells/outlines and 7 top, 6 bottom layers so the spring itself is solid. After printing, separate carefully with a palette knife, butter knife, etc. How easily the springo separates will vary based on your printer, filament, slicer settings, etc.. So good luck and please share your results!
You should be very cautious separating the layers of the Springo, but once it's correctly popped apart these things are surprisingly resilient for PLA prints.
Model photographed was printed with MatterHackers PRO PLA Neon Green (http://bit.ly/NeonGreenPLA). It looks wicked, and glows under a black light!
Descripción original del autor, publicada en Thangs.
