Tree for Gloomhaven
por Jon Robelia en Thingiverse
Overlay tile replacement for the board game Gloomhaven. Canopy is partially hollow and removable so you can see underneath if it gets in the way. No supports needed! Tile Count: 3 Revisions: V2: I would print V2 as the default for Gloomhaven, I tried to optimize this one for scale. It also has the..
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Jon Robelia.
Archivos (6)
- Tree_for_Gloomhaven_V2_-_Base_for_Hollow_Canopy.stl STL
- Tree_for_Gloomhaven_V2_-_HollowCanopy.stl STL
- Tree_for_Gloomhaven_V1_-_Pinned_Base.stl STL
- Tree_for_Gloomhaven_V1_-_Pinned_Canopy.stl STL
- Robagon3D_Tree_for_Gloomhaven_V2_-_HollowCanopy_Half1.stl STL
- Robagon3D_Tree_for_Gloomhaven_V2_-_HollowCanopy_Half2.stl STL
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 72,069
- Publicado
Sobre este modelo
Overlay tile replacement for the board game Gloomhaven. Canopy is partially hollow and removable so you can see underneath if it gets in the way. No supports needed! Tile Count: 3 Revisions: V2: I would print V2 as the default for Gloomhaven, I tried to optimize this one for scale. It also has the most branches when the canopy is removed. The canopy rests on the top of the branches in one orientation. V1: This older version has a little bigger canopy and thicker trunk/branches but is nice enough that I thought I'd include it. The canopy attaches to the base with three pins. 2019-12-08: Added a split canopy of V2 for smaller printers. Check out my cults3d.com page for premium and multi-material models.
Descripción original del autor, publicada en Thingiverse.
