Transforming Chopsticks
This is a fun little experiment relating to compliant mechanisms (though this one does rely on one moving part: the marble).
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Devin B.
Archivos (1)
- transformingchopsticks.stl STL · 777 KB
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 93
- Publicado
Sobre este modelo
This is a fun little experiment relating to compliant mechanisms (though this one does rely on one moving part: the marble).
If you've seen my Cool Prints video (https://youtu.be/PgDJlLqeTdo) about it, you know this doesn't function 100% as intended, but it's still pretty cool!
Print at about 4 shells, 35% infill. I used PLA, though other filaments may have better results. Print includes a small helper disc at the end since bed adhesion can be a challenge with a long thin part like the chopsticks. You can just rip that off after printing or clean it up with an Xacto knife.
Add one standard 9/16" (14mm) marble as the pivot point.
Descripción original del autor, publicada en Thangs.
