Toy Sword or Lightsaber (collapsible)
por Plastic Flow en Printables
A collapsible toy sword/lightsaber that prints without support. Is a bit shorter than other models, so it prints faster.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Plastic Flow.
Archivos (9)
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 4,867
- Publicado
Sobre este modelo
This is a collapsible sword that is similar to other models that can be found on this site. Choose between two different designs, a sword or lightsaber. Everything can be printed without support. The size is more aimed at children, but this comes with the benefit of faster print-times compared to similar models. The extended blade is approx. 43 cm long.
Print Setting recommendations: - Material: PETG or PLA (I tested both but PETG is probably more durable if intended as a toy) - Layer height: 0.25mm - Perimeters: 2 (or more) - Solid top/bottom layers: 4 - Infill: 15% (only matters for the hilt) - Support: no - Brim: outer brim on the blade parts recommended for adhesion
Post Processing: Make sure to cut or file away the brim or elephant foot nicely. This makes it easier for the blades to collapse.
Update December 5th, 2023: Changed the license to allow for commercial use.
Descripción original del autor, publicada en Printables.
