Ticket To Ride: Europe - Card Tray

I have found that Ticket To Ride Card Tray is for American version which is the same box size but cards in TTR:Europe are a little bit bigger (87x57mm), so I was not able to use it with Ticket to Ride Insert which I already printed. So I decided to make a new card tray that can fit European version inside. Because of the limited space I made it consist of several parts: - BodyStartTray + BodyEndTray fit on top of each other, holding together with magnets in gaming mode. Use for 5 wagon EU size cards market - CardTrayWithCorners - has 4 corners so they hold cards in place. Size: 89x60x36mm - CardTrayWithBack - has one open side so it is easier to take cards. Size: 89x60x36mm

As you can see, both deck card trays are the same size, so you can print either combination of them. Firstly I made 4-corners one, it was nice, but sometimes you struggle getting cards from there. So I left it for the new routes deck (which we rarely use) and made the TrayWithBack which makes it easier to get wagon cards. Magnets: - I used ⌀ 5mm x 1mm x 4pcs - but I recommend using thicker ones (like 2 mm), because mine are too weak to hold tray weight in the air. Mine have nice grip on the table though, no wobbling. - Used hot glue to hold them in place - IMPORTANT! Be sure to orient them properly, so they attract instead of repulse

Improvements: - Retrospectively it could use more vertical space if "Insert" was adapted for EU version as well. Because of the limited depth (36mm) wagon cards deck is bigger than the wagon card holder unless you put "TrayWithBack" on its back. - BodyStart/BodyEnd sometimes slide sideways in the "folded" state. To prevent this I recommend packing everything like on photo 4.