Super Glider - Easy to print

the final version of my glider model, which is very easy to print. all it takes is one print, a little editing, and it's ready to fly! Recommended print parameters: 3 walls 20% infil Material PET-G (can use PLA but PLA is brittle so there is a high chance the plane will crack) Pre-flight instructions: list of needs: hair dryer, screw and nut M4 use a hair dryer to adjust the wings as shown in the photo. under the wings with markers so that the wings are V-shaped: the center of gravity of the aircraft needs to be adjusted for the best result. screw a screw with a diameter of M4 and a length as required into the front hole. according to the photo: glue the holder in place of the bottom groove for easy throwing adjust the tail flaps for better flight

enjoy flying!