RobBob the Robot Head
RobBob is a 2 degree of freedom robot head that is powered by bevel gears! Spin one knob and robBob's head turns. Turn the knobs together and robBob will tilt his head up and down.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a JB V.
Archivos (16)
- Base (mechanical Version).stl STL · 237 KB
- Bevel Gears.stl STL · 1,0 MB
- C-Clamps.stl STL · 211 KB
- End Knob Bracket Side.stl STL · 763 KB
- End Knob Shaft Side.stl STL · 766 KB
- Head.stl STL · 546 KB
- Pre Layout - Mechanical Version.stl STL · 4,4 MB
- Shaft Mounts.stl STL · 334 KB
- Shaft.stl STL · 290 KB
- U-Bracket.stl STL · 343 KB
- Base (servo version).stl STL · 363 KB
- Pre Layout - Servo Version.stl STL · 4,2 MB
- Servo Brackets.STL STL · 275 KB
- Servo Interface Bracket Side.stl STL · 536 KB
- Servo Interface Shaft Side.stl STL · 322 KB
- Print and Assembly Instructions.txt TXT
- Categoría
- Juguetes y juegos
- Formatos
- STL, TXT
- Descargas
- 128
- Publicado
Sobre este modelo
RobBob is a 2 degree of freedom robot head that is powered by bevel gears! Spin one knob and robBob's head turns. Turn the knobs together and robBob will tilt his head up and down.
You can add some servo motors and an arduino board to give RobBob some life!
This video show the engineering process behind RobBob.
The files are available for both the mechanical version as well as the servo powered version. You can find info on how to make the servo version work here
Recommended print settings: Layer Height: 0.2mm Nozzle: 0.4mm Infill: 15-18% Filament Use: ~100g
Descripción original del autor, publicada en Thangs.
