RAVION Ontos Buffer Tube Stock
por Aren en Printables
I wanted to use a buffer tube stock, but I only have TinkerCad.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Aren.
Archivos (5)
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
**This has not been tested, and is my first upload on Printables :) I plan to test print eventually, and make sure the stock locks into place as intended.** I wanted to use a buffer tube stock, but I only have TinkerCad. I merged these two designs, and changed the threaded cap to a female threaded end to clamp the pieces together. This matches the same spring geometry of the RAVION, it's not an extended tube so it should fit the same on a bed. This was using the standard trigger pull with the pivot sear.
Supports are still required, and use the same print settings as the original Ontos/RAVION
Descripción original del autor, publicada en Printables.
