Puzzle Plane
por Deemoss en Thingiverse
A puzzle plane held together by magnets. A great creative project for adults and children alike! SELL PRINTS OF MY DESIGNS! License available here: https://cults3d.com/en/3d-model/various/commercial-license-for-all-my-models DISCLAIMER Due to their small size and the potential risk of detachment...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Deemoss.
Archivos (19)
- Engine_B_x2.stl STL · 2,4 MB
- Engine_A_x2.stl STL · 3,5 MB
- Windshield.stl STL · 977 KB
- Wing_L.stl STL · 2,4 MB
- Horizontal_St_R.stl STL · 2,4 MB
- Landing_Gear_L.stl STL · 1,6 MB
- Landing_Gear_R.stl STL · 1,8 MB
- Tyre_Front.stl STL · 2,9 MB
- Fuslage_Bottom.stl STL · 3,5 MB
- Wing_R.stl STL · 2,4 MB
- Horizontal_St_L.stl STL · 2,5 MB
- Fuselage_Top_Front.stl STL · 1,1 MB
- Fuselage_Top_Back_A.stl STL · 1,3 MB
- Vertical_Stabiliser.stl STL · 2,3 MB
- Cockpit.stl STL · 1,1 MB
- Fuselage_Top_Back_B.stl STL · 1,7 MB
- Tyre_Rear_Half_x4.stl STL · 1,7 MB
- Wheel_Front_Half_x2.stl STL · 678 KB
- Below_Cockpit.stl STL · 2,5 MB
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 41,965
- Publicado
Sobre este modelo
A puzzle plane held together by magnets. A great creative project for adults and children alike!
SELL PRINTS OF MY DESIGNS! License available here: https://cults3d.com/en/3d-model/various/commercial-license-for-all-my-models DISCLAIMER Due to their small size and the potential risk of detachment, magnets may pose a hazard to young children. As a result, this particular design is not recommended for children between the ages of 0 and 3. https://www.org/English/safety-prevention/at-home/Pages/Dangers-of-Magnetic-Toys-and-Fake-Piercings.aspx DESCRIPTION Should you need higher quality STLs or the source STEP file so that you can easily make changes to the model, consider purchasing those here https://cults3d.com/en/3d-model/game/puzzle-plane In addition to the printed parts, you will require the magnets (3mm tall, 6mm diameter). There are 63 magnet sockets in total but I used probably 55 magnets. Dimensions (L x W x H): 217mn x 255mm x 116mm Cut up for minimal support requirement. To secure the magnets in the pockets, I used Super Glue which proved to be effective. However, caution must be exercised during this process as any spillage of the glue may cause the plastic components to adhere together.
Descripción original del autor, publicada en Thingiverse.
