Pumpking & Pumpqueen - Royal Pumpkin Fidget Clicker Duo

Hear ye, hear ye! Please welcome PUMPKING & PUMPQUEEN, the newest royalty of our little pumpkin patch! 👑 A silly 3D printable clicker duo with interchangeable crowns for your desk.

By royal decree, the crown toppers also fit the previous PUMPKIN clicker batch, so even the humblest pumpkin may now ascend the throne.

────⋆⋅☆⋅⋆──

⚜️ INCLUDED IN THIS SET

- 2 different bottoms ↳ PUMPKING & PUMPQUEEN

- 2 crown toppers ↳ one smaller crown and one bigger crown ↳ both crowns fit either bottom

↳ Each bottom comes with or without a keychain hole for ball chains. 🏷️

↳ The crowns are also compatible with the previous PUMPKIN clicker batch, giving you a few more combinations to play with!

→ As usual, everything comes in STL files and also pre-colored 3MF files.

────⋆⋅☆⋅⋆──

⚠️ PRINTING NOTES

The whole duo prints without supports!

My recommended settings:

- 0.16 mm layer height

- 4 walls

- 0.3 mm top surface line width

- Variable layer height

Please make sure you have good bed adhesion when printing the small toppers, and check the included print settings before starting.

↳ These clickers are designed for MX-compatible switches. Please see my Patreon guide for switch and assembly information.