print-in-place treasure chest
por Severeon en Printables
A small 100mm x 80mm pirate like treasure chest with print in place hinges and a snap fit lid
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Severeon.
- Categoría
- Juguetes y juegos
- Formatos
- STL, OBJ
- Descargas
- 4,201
- Publicado
Sobre este modelo
This is my first attempt at modeling anything more complex than a toy rocket in fusion360. This box features print in place hinges and a snap / latch to hold it closed. The sides have mostly decorative handles. This prints well at .2mm layer height. You'll need to print the box and two handles. Supports may be needed depending on the material you use. I use paint on supports, automatically enforcing supports at 15 degrees. You may find the lid of the box can warp during print - this can be fixed with a brim or helper disks.
Descripción original del autor, publicada en Printables.
