Print in place balisong
por 3dDaveJ en MyMiniFactory
Hi, I wanted to see if i could make print in place balisong, turns out it can be done and it's not that difficult.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a 3dDaveJ.
Archivos (2)
- Categoría
- Juguetes y juegos
- Formatos
- STL, JPG
- Descargas
- 497
- Publicado
Sobre este modelo
Hi, I wanted to see if i could make print in place balisong, turns out it can be done and it's not that difficult.
This model (like most of print in place things) needs a bit more time for preparing before the print to make sure that it will print without any problem.
Notes: You must have good support settings, before the print you must view the model in layer mode, if there is no gap where the handle and the blade joins, you must tweak the horizontal expansion setting. don't change the orientation, you can use 'lay flat' option only to make it a little bit quicker to print.
Descripción original del autor, publicada en MyMiniFactory.
