Panhard EBR (1951) FL-11 Armoured Vehicle 1/35

This release is a pure 3D‑print‑only version with no additional purchased parts required. CyberBrick mechatronics components are not supported in this build.

If you’d like the motorized CyberBrick variant, please head over to collor’s profile page. https://makerworld.com/en/@collor EBR 1954 4WD Remote Control Armored Reconnaissance Vehicle · Motorized Rotating and Tilting Turret · Independent Suspension · CyberBrick Compatible: https://makerworld.com/en/models/3277538-ebr-1954-4wd-remote-control-armored-reconnaissance#profileId-3717190

================================

📋 Recommended Print Settings (For Best Results)

- Filament: PLA. Different materials have different shrink rates, so using other filaments might cause fitting issues or dimensional errors during assembly.

- Slicer: Bambu Studio. I recommend using my default profile — I’ve tuned it specifically for this model.

- Ambient Temperature: If you’re using an open-frame printer like the A1 or A1 Mini, keep your room above 20°C (68°F) to prevent warping.

- Print Bed Preparation: Wash with soap and water, then dry thoroughly to ensure good adhesion. For small parts, apply a glue stick for better bed adhesion.

🔧 Assembly Diagram Notes

- Blue Lines: Require super glue for assembly. I use Gorilla Super Glue.

- Yellow Lines: These are moving parts. Do not apply glue here.