Nintendo Switch 2 Single Joy-Con Grip with Trigger Buttons
por Chongfun en Printables
An easily-printable grip for either the left or right Nintendo Switch 2 JoyCon.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Chongfun.
Archivos (3)
- Categoría
- Juguetes y juegos
- Formatos
- STL, 3MF
- Descargas
- 3,431
- Publicado
Sobre este modelo
Like the original model, it's printable without generated supports, though you can choose to enable supports to avoid sagging bridges. I printed with a brim, but the brim may not be necessary if you have good bed adhesion. After printing, remove the trigger's built-in supports marked in red in the following photos (ideally with flush cutters, but needle-nose pliers should work as well). Changelog 2025-06-10 - reduced overall size to improve access to stick and buttons - repositioned triggers to make them easier to press
2025-06-06 - initial remix
Descripción original del autor, publicada en Printables.
