Modular Toy Robot Arm
por tmackay en Printables
Following on from my first toy robot arm This one is a bit more modular and can be used as a toy, desk lamp,…
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a tmackay.
Archivos (9)
- Categoría
- Juguetes y juegos
- Formatos
- STL, SCAD
- Descargas
- 2,328
- Publicado
Sobre este modelo
Following on from my first toy robot arm
This one is a bit more modular and can be used as a toy, desk lamp, microphone or camera stand via swappable add-on components. The gearbox code has also been fully reworked.
More components to come.
Also on GitHub
Print at 0.2mm layer height and ensure there is a 1-layer gap in the ring gears after slicing. Use a sharp edge to de-laminate the 1-layer gaps (listen for the "crack"). Turn the knob just a little to get the gears moving, working back and forth gently. A final tap with a rubber mallet should free everything up. Then apply petroleum jelly or lubricant of choice to gears.
Category: Mechanical Toys
Descripción original del autor, publicada en Printables.
