Miniature Golf - Course One - Par 3
por Adam Freeman en MyMiniFactory
Updated 25/01/26: Reuploaded some of the stl files to remove some errors.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Adam Freeman.
Archivos (24)
- Golf_Base 1.Stl STL
- Golf_Club 1.Stl STL
- Golf_Club2 1.Stl STL
- Golf_Club3 1.Stl STL
- Golf_Course 1.Stl STL
- Golf_Flag1.stl STL
- Golf_Flag2.stl STL
- Golf_Foot 1.Stl STL
- Golf_Icosphere 1.Stl STL
- Golf_Key 1.Stl STL
- Golf_L10 1.Stl STL
- Golf_L12 1.Stl STL
- Golf_L15 1.Stl STL
- Golf_L18 1.Stl STL
- Golf_L21 1.Stl STL
- Golf_L8 1.Stl STL
- Golf_R10 1.Stl STL
- Golf_R12 1.Stl STL
- Golf_R15 1.Stl STL
- Golf_R18 1.Stl STL
- Golf_R21 1.Stl STL
- Golf_R8 1.Stl STL
- Golf_Sphere 1.Stl STL
- Golf_Swing 1.Stl STL
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 146
- Publicado
Sobre este modelo
Updated 25/01/26: Reuploaded some of the stl files to remove some errors.
...
Welcome to round one of the first day of The World Miniature Masters Open Tournament Championship!
We start today with a look at Course One -Par 3...
I highly recommend 5mm ball bearings as your golf ball of choice and a sturdy flat surface is a good starting point and then (after screwing the feet in) grab a flat head screw driver and with one of your ball bearings placed in the circle indent in the base, spend some time leveling.
Once the ball stays still in the centre you can pop the course on and start your 64 player desktop miniature golf tournament! Bit of a squeeze though, so maybe start with just two.
The Course and Base print diagonally on a (minimum) 200x200 bed
This is a bit different to what I normally design but it was a nice change and I would like to take a crack at a course two.
Happy putting!
--PATREON & PATREON SHOP. --https://www.patreon.com/3DFreeman
Thanks for your continued support.
Descripción original del autor, publicada en MyMiniFactory.
