Life (or anything) counter for table-top games
por Scott Reece en Thingiverse
This is an original life (or points or arrows or anything) counter for games like D&D or Magic the Gathering. IMPORTANT NOTE: I recommend printing the 'all except tube' variation in one print, then printing the tube by itself because it's the most likely to fail in my experience. The other files...
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Scott Reece.
Archivos (12)
- Life_Counter_V1.00-clip.stl STL · 22 KB
- Life_Counter_V1.00-tube.stl STL · 13 KB
- Life_Counter_V1.00-one_ring.stl STL · 112 KB
- Life_Counter_V1.00-sides.stl STL · 49 KB
- Life_Counter_V1.00-three_springs.stl STL · 219 KB
- Life_Counter_V1.00-one_spring.stl STL · 73 KB
- Life_Counter_V1.00-all.stl STL · 638 KB
- Life_Counter_V1.00-three_rings.stl STL · 335 KB
- Life_Counter_V1.00-all_except_tube.stl STL · 625 KB
- Two-rings-clip-and-tube-OPTIONAL.stl STL · 41 KB
- Number-only-OPTIONAL.stl STL · 94 KB
- test.txt TXT · 1 KB
- Categoría
- Juguetes y juegos
- Formatos
- STL, TXT
- Descargas
- 40,739
- Publicado
Sobre este modelo
This is an original life (or points or arrows or anything) counter for games like D&D or Magic the Gathering. IMPORTANT NOTE: I recommend printing the 'all except tube' variation in one print, then printing the tube by itself because it's the most likely to fail in my experience. The other files are included for your convenience. If you have trouble printing the tube, try it with a raft and/or supports. Like my work? Check out my Patreon page: https://patreon.com/scottreece 2019-08-20 edit: I just added 2 updated files: Number-only-OPTIONAL.stl and Two-rings-clip-and-tube-OPTIONAL.stl. Both were uploaded earlier, but had some problems. The scales were off by 100x and the tube was missing.
Descripción original del autor, publicada en Thingiverse.
