Hextraction Tsunami Tile
The first automatic triple dispenser tile. Watch the video to see it in action.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a NoStep.
Archivos (4)
- Tsunami Flipper Right.STL STL · 32 KB
- Tsunami Flipper Left.STL STL · 32 KB
- Wave Base Right.SLDPRT SLDPRT · 104 KB
- Wave Base Left.SLDPRT SLDPRT · 104 KB
- Categoría
- Juguetes y juegos
- Formatos
- STL, SLDPRT
- Descargas
- 369
- Publicado
Sobre este modelo
The first automatic triple dispenser tile. Watch the video to see it in action.
Hardware / Printing - One M3x16 screw (or longer) - Two M3 washers - PLA, 2 walls, 10% infill, no supports
Assembly 1. Insert an M3x16 screw into the flipper, stack 2 washers on the screw, then install the flipper. Crank it down until it stops rotating freely. 2. Slowly back out the main screw 1/8th of a turn. Repeat until the flipper freely rotates.
This tile is part of my _Counterweight Dispensers Pack_. Check the others out. - 180zu https://than.gs/m/1327652 - AltWave https://than.gs/m/1031259 - Anchor https://than.gs/m/1288074 - K-zu https://than.gs/m/1288115 - Overdrive Wave https://than.gs/m/1031248 - Wave https://than.gs/m/1031247 - Sailboat https://than.gs/m/1288126 - Tsunami https://than.gs/m/1031250 - Twozu https://than.gs/m/975596
Descripción original del autor, publicada en Thangs.
