Hextraction Omni-Flip Tile
An all-in-one combined Flip-Flop and Turnstile. Watch the video to see it in action.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a NoStep.
Archivos (2)
- OmniFlip Base.STL STL · 179 KB
- OmniFlip Flipper.STL STL · 322 KB
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 277
- Publicado
Sobre este modelo
An all-in-one combined Flip-Flop and Turnstile. Watch the video to see it in action.
Hardware - one M3x10 screw (or longer) - two M2x12 screws - one M3 washer
Assembly 1. Install two M2x12 screws into the top of the flipper. They must protrude past the bottom of the flipper. 2. Insert an M3 screw into the flipper, stack a washer on the end of the screw, then install the flipper. It should freely spin and barely wobble. The M2 screws should not protrude past the bottom of the tile, should provide 120 rotation lock to the flipper and should not grind the wall of the base.
Notes This base is the same used in the Alternator Tile (https://than.gs/m/1116292).
This tile is part of my _Mechanical Flippers Pack_. Check the others out. - 180 https://than.gs/m/1116280 - Alternator https://than.gs/m/1116292 - Bounce Flop https://than.gs/m/1327656 - Follower https://than.gs/m/1228246 - I-Flop https://than.gs/m/1288093 - JL Flop https://than.gs/m/1327657 - Omni-Flip https://than.gs/m/1228247 - Side Flop https://than.gs/m/1116295 - T-Switch https://than.gs/m/1116307 - Trident https://than.gs/m/1228248 - Tri-Switch https://than.gs/m/1288137 - XC Flop https://than.gs/m/1327667
Descripción original del autor, publicada en Thangs.
