Hextraction Alternator Tile

A Flip-Flop like tile with an additional gutter-drop and pass-through. Watch the video to see it in action.

This tile is part of my _Mechanical Flippers Pack_. Check the others out. - 180 https://than.gs/m/1116280 - Alternator https://than.gs/m/1116292 - Bounce Flop https://than.gs/m/1327656 - Follower https://than.gs/m/1228246 - I-Flop https://than.gs/m/1288093 - JL Flop https://than.gs/m/1327657 - Omni-Flip https://than.gs/m/1228247 - Side Flop https://than.gs/m/1116295 - T-Switch https://than.gs/m/1116307 - Trident https://than.gs/m/1228248 - Tri-Switch https://than.gs/m/1288137 - XC Flop https://than.gs/m/1327667

Hardware - one M3x10 screw (or longer) - two M2x12 screws - one M3 washer

Assembly 1. Install two M2x12 screws into the top of the flipper. They must protrude past the bottom of the flipper. 2. Insert an M3 screw into the flipper, stack a washer on the end of the screw, then install the flipper. It should freely spin and barely wobble. The M2 screws should not protrude past the bottom of the tile, should provide 120 rotation lock to the flipper and should not grind the wall of the base.

Notes This base is the same used in the Omni-Flip Tile (https://than.gs/m/1228247).