Hextraction 180 Tile
A tile that does a 180 degree spin. It switches between being a DI~~O~~ and a ~~O~~IC. Watch the video to see it in action.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a NoStep.
Archivos (2)
- 180 Base.STL STL · 243 KB
- 180 Flipper.STL STL · 289 KB
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 493
- Publicado
Sobre este modelo
A tile that does a 180 degree spin. It switches between being a DI~~O~~ and a ~~O~~IC. Watch the video to see it in action.
Hardware - one M3x10 screw (or longer) - one M2x12 screw - one M3 washer
Assembly 1. Install an M2x12 screw into the top of the flipper. It must protrude past the bottom of the flipper. 2. Insert an M3 screw into the flipper, stack a washer on the end of the screw, then install the flipper. It should freely spin and barely wobble. The M2 screw should not protrude past the bottom of the tile, should provide 180 degree rotational lock to the flipper and should not grind the wall of the base.
This tile is part of my _Mechanical Flippers Pack_. Check the others out. - 180 https://than.gs/m/1116280 - Alternator https://than.gs/m/1116292 - Bounce Flop https://than.gs/m/1327656 - Follower https://than.gs/m/1228246 - I-Flop https://than.gs/m/1288093 - JL Flop https://than.gs/m/1327657 - Omni-Flip https://than.gs/m/1228247 - Side Flop https://than.gs/m/1116295 - T-Switch https://than.gs/m/1116307 - Trident https://than.gs/m/1228248 - Tri-Switch https://than.gs/m/1288137 - XC Flop https://than.gs/m/1327667
Descripción original del autor, publicada en Thangs.
