GameSir G8+ Vertical Switch 1 & 2 Insert for Emulation

Some games play better vertically. This insert fits the GameSir G8+ and holds your Switch in portrait orientation, so you can play vertical games the way they were meant to be played. Features - Fits both Switch 1 and Switch 2 (the cradles slide to adjust width)

- 60 mm jaws for a secure hold on the heavier console

- Relief channel in the jaws, so the power and volume buttons aren’t pressed

- End stops on the back plate keep the cradles from sliding off

Assembly: Slide each cradle onto the back plate. When it reaches the end-stop tab, press the tab down and push the cradle past it. The tab springs back up and holds the cradle on. To remove a cradle, press the tab and slide it off. Print settings - 3 perimeters

- 15% gyroid

- No supports needed

- PLA

Note: this back plate is not interchangeable with the G8+ phone insert’s back plate. The end stops are in different positions. Related - Phone version for G8, G8+, X2, X5s, and more:

- Don’t have a printer? Printed inserts are available in my Etsy shop: https://www.etsy.com/listing/4340806220/gamesir-g8-vertical-switch-1-2-insert