Fallout Terminal Streamdeck/ Arcade for Badgeware Tufty
por David en Printables
A Fallout inspired housing for Badgeware Tufty, use it as an arcade, streamdeck or to show your stats!
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a David.
Archivos (14)
- Badgeware_Tufty_Fallout_Terminal_Streamdeck_Together.3mf 3MF · 649 KB
- Badgeware_Tufty_Fallout_Terminal_AllInOne.3mf 3MF · 325 KB
- Top_All_Parts.3mf 3MF · 53 KB
- Body.3mf 3MF · 42 KB
- Screen.3mf 3MF · 31 KB
- Keypad_with_Buttons.3mf 3MF · 216 KB
- Top.3mf 3MF · 26 KB
- Back_Button_Claw.3mf 3MF · 22 KB
- Button_Front_rectangle.3mf 3MF · 20 KB
- Button_Front.3mf 3MF · 30 KB
- Button.3mf 3MF · 26 KB
- Body.3mf 3MF · 42 KB
- Screen.3mf 3MF · 31 KB
- Keypad.3mf 3MF · 206 KB
- Categoría
- Juguetes y juegos
- Formatos
- 3MF
- Descargas
- 18
- Publicado
Sobre este modelo
Assembly: Take the top, the top buttons and the claws. Set the buttons with the small side looking outside and slide the claws over the prongs Next take the Keypad, put the flatter round and the square buttons in place, set the gamepad addon ontop and screw it in with 2 m2.5x6 (or 8) screws. Next part: take your Tufty, and slide it into the nook of the screen, and clip it into the two pins. Due to gravity it will hold. Finally connect the ribbon to the gamepad and the Badgeware routed through the main body, add a USB-C cable and route it through the hole in the back and put all parts into place. Assembly finished! Now flash your software and you have a new terminal next to your computer, to look at your stats, control your music or an arcade, ready to play Doom.
For full clarity: the first picture is AI rendered.
Descripción original del autor, publicada en Printables.
