Embercrest Dragon - Articulated Standing Fidget

Meet Embercrest, a wingless dragon with a broad jaw, swept horns, twin flame-like crests, and a spade-shaped tail. Its seven-section body prints flat in one piece, then bends into gentle poses and stands on its built-in feet—a little fantasy companion for your desk or display shelf. FEATURES • Seven close-fitting sections connected by six enclosed articulating hinges • Concealed hinge pins, with flat broad faces and recessed details on both sides • Flame-like back crests, shield-shaped armour marks, and a detailed face • A 12 mm body and complete front and rear feet for a wider standing footprint • Approximately 173 × 51.5 × 12 mm overall • One-colour, print-in-place design with no supports, hardware, glue, or assembly PRINTING Print flat at 100% scale with a 0.4 mm nozzle. The included profile uses 0.20 mm layers, 3 walls, and 12% gyroid infill, with supports and brim turned off. Keep the interlocked sections together; do not split or rearrange individual links. The supplied project is configured for the Bambu Lab H2C right nozzle and was prepared for VOXEL PLA Plus. Its footprint fits within a 256 × 256 mm build area; choose the correct printer, filament, and build-plate settings for your own setup. The supplied cooling and bed settings are specific to the creator’s setup. Gold gives the crests a warm, fiery look, but any favourite PLA colour can make Embercrest your own. MOVEMENT & STANDING Let the plate cool before gently releasing the dragon. Support neighbouring sections and ease each joint into small bends. The body folds through its thickness and permits smaller sideways swivels. Spread a pose across several joints rather than forcing a single joint past its stops, and avoid pulling on the horns or tail. Start with both feet flat and the body in a neutral or shallow pose. Deep bends can change balance. A characterful desk companion, fantasy collectible, or handmade gift for a dragon lover. If you print one, share a photo—I’d love to see your colour choice and how you pose your Embercrest!