DnD Travel Dice Holder
por dbordak en Printables
Travel dice holder that holds full sets of DnD dice (i.e. d4, d6, d8, 2d10, d12, d20)
Licencia
Uso comercial permitidoPuedes usarlo, modificarlo y venderlo manteniendo el aviso de copyright del autor.
Al descargar aceptas respetar la licencia y dar crédito a dbordak.
Archivos (14)
- dndiceholder_thicc_lid.stl STL · 2,5 MB
- dndiceholder_thicc_x5.stl STL · 1,9 MB
- dndiceholder_thicc_x4.stl STL · 1,9 MB
- dndiceholder_thicc_x3.stl STL · 1,9 MB
- dndiceholder_thicc_x2.stl STL · 1,9 MB
- dndiceholder_thicc_x1.stl STL · 1,9 MB
- dndiceholder.scad SCAD · 4 KB
- dndiceholder_x5.stl STL · 571 KB
- dndiceholder_x3.stl STL · 571 KB
- dndiceholder_x2.stl STL · 571 KB
- dndiceholder_x1.stl STL · 571 KB
- dndiceholder_x4.stl STL · 571 KB
- dndiceholder_lid.stl STL · 856 KB
- dndiceholder_lid_lip.stl STL · 794 KB
- Categoría
- Juguetes y juegos
- Formatos
- STL, SCAD
- Descargas
- 1,195
- Publicado
Sobre este modelo
Variant of my Travel Dice holder for holding an entire set – or up to 5 sets – of DnD dice. The lid screws on, and you can string the entire thing, which even prevents you from losing the lid. See here for the original: https://www.printables.com/model/435582-travel-dice-holder The lid uses the Knurled Surface Library here: https://www.thingiverse.com/thing:32122 and both parts use the threading library here: https://github.com/adrianschlatter/threadlib
The threaded parts (and knurls) should be printed at a smaller width (I used 0.12mm and 0.15mm), but everything below the threads doesn't really matter (I used variable width to print that at 0.3mm)
IMPORTANT: The threads on the lid should be thick to prevent damage when screwing/unscrewing. I used 5 walls when printing the lid.
Descripción original del autor, publicada en Printables.
