Candy Corn Slinky • Halloween Fidget • No AMS

🎃 Candy Corn Slinky 🎃 Please consider boosting if you can so I can continue making FREE models :) Boost MeIf you enjoy my work please consider leaving a thumbs up! A boost is never expected but always appreciated!Celebrate Halloween with a candy corn twist on the classic slinky! This candy corn slinky is supper satisfying and stretches over a meter for the large version!

The model is designed to print cleanly in PLA while keeping multicolor waste to a minimum. The entire print only requires two color changes, making it much more efficient than typical multicolor prints.

No AMS: I have included a print profile for those without an AMS that includes two pre programmed pauses for you to manually swap filaments. To print as pictured, Start with yellow, then orange and then white. Feel free to change up the iconic colors and have fun with it too!

Notes: Ignore warning to enable supports, they are not needed. I have only tested this print with PLA basic. Test other filaments at your own risk.

Printing Notes

- ensure build plate is very clean for maximum adhesion

- do not enable supports

- .20mm layer height

- 15% gyroid infill

- 3 wall loops

Commercial License

I have commercial licensing available here on MakerWorld or on my Patreon! MembershipCommercial Licensing Available For $4.99/monthCheck out my other models!