Bullet Bill Nintendo Switch Cartridge Storage
por JayCreates en Printables
Famous for blowing plumbers out of the sky, now good for...storage?
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a JayCreates.
Archivos (9)
- BB-eye-pupils-Black.stl STL · 314 KB
- BB-eye-white-left.stl STL · 850 KB
- BB-eye-white-right.stl STL · 791 KB
- BB-red-insert.stl STL · 201 KB
- BB-use-support-lowerteeth.stl STL · 155 KB
- BB-use-support-upperteeth.stl STL · 171 KB
- Bullet Bill Bottom - Black.stl STL · 289 KB
- Bullet Bill Top - Black.stl STL · 512 KB
- Bullet Bill Top Insert - Black.stl STL · 56 KB
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
This remix of a pretty great Bullet Bill design can store up to 10 Nintendo Switch cartridges. Also required are some rare earth magnets - 5mm by 3mm and 3mm by 3mm. The 5x3 magnets are glued into the Bullet Bill Bottom file. For the top, I use a little glue to hold in the Red Insert, push the pupils into each eye, and glue the eyes and the teeth into the assembled black top and red insert. Finally, I glue the Bullet Bill Top - Insert part into the "opening" under the top and then glue the 3x3 magnets under there. Pay attention to polarity!
Descripción original del autor, publicada en Printables.
