Bathtub Fishing Rod With Spinnable Reel
por DakotaWLacy en Printables
A simple fishing rods for kids in the tub with a spinnable reel and floating sea creatures ready to be hooked!
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a DakotaWLacy.
Archivos (12)
- FishingPole_Square.stl STL · 34,1 MB
- FishingPole_Round.stl STL · 27,7 MB
- Reel_Handle.stl STL · 4,3 MB
- Pole_Handle.stl STL · 767 KB
- Reel_Main.stl STL · 9,8 MB
- Reel_Attachment.stl STL · 17,3 MB
- Hook.stl STL · 41,2 MB
- FISH.stl STL · 1,4 MB
- JELLYFISH.stl STL · 2,2 MB
- CRAB.stl STL · 2,3 MB
- TURTLE.stl STL · 1,6 MB
- STARFISH.stl STL · 2,5 MB
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 2,176
- Publicado
Sobre este modelo
READ BEFORE PRINT - PRINT FISH WITH 5% INFIL TO FLOAT - PRINT HOOK WITH 100% INFIL TO SINK - PRINT REEL WITH PETG TO AVOID BREAKAGE - USE SUPPORTS ON POLE - USE BRIM ON REEL HANDLE
Reel snap fits into the attachment once on the pole. Be careful because it can break if you push too hard. PLA was not tested on it so i can only recommend PETG for the reel. See last image to see the connection. Tolerances can be a little tight and might require some play. A touch of glue in the handle kept it on the pole but should stay relatively snug without it. Tie a string to the pole and to the hook and you're ready to become a master angler. ENJOY!
Descripción original del autor, publicada en Printables.
