Barbie Doll Laptop (Foldable)
por Bob Torrence en Thingiverse
This is a remix of the Barbie Doll Laptop computer. I re-scaled to 1:6 and modified hinges to allow opening to approx 100 degrees. Assemble the two pieces by inserting lengths of 1.75 filament into each end, cut flush. Use a #8-32 bolt, heating end with flame, to dimple each filament end to bind it.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Bob Torrence.
Archivos (4)
- Categoría
- Juguetes y juegos
- Formatos
- STL
- Descargas
- 22,465
- Publicado
Sobre este modelo
This is a remix of the Barbie Doll Laptop computer. I re-scaled to 1:6 and modified hinges to allow opening to approx 100 degrees. Assemble the two pieces by inserting lengths of 1.75 filament into each end, cut flush. Use a #8-32 bolt, heating end with flame, to dimple each filament end to bind it with the display piece. (Note: After printing, if you need to clean up hole I.D.'s. before inserting filament, use #50 (0.070") drill.) Print Display and Base individually. The other two models are just to show finished assembly in open and closed position.
Descripción original del autor, publicada en Thingiverse.
