Zipper Pull using paperclip
por Scott Reiling en Thingiverse
Zipper pull replacement using a paperclip for a strong connection to the zipper. There are several posts inside and should fit a variety of paper clips, some bending may be required. I used 3 M2x6 screws to hold it together. update 11/2/17 Added a second smaller pull should work with a #1 paperclip.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Scott Reiling.
Archivos (10)
- ZipperPull_-_Cover.stl STL · 186 KB
- ZipperPull_-_clip.stl STL · 278 KB
- ZipperPull_-_Cover.stl STL · 243 KB
- ZipperPull_-_clip.stl STL · 278 KB
- Small_Zipperpull_-_clip.stl STL · 197 KB
- Small_Zipperpull_-_Cover.stl STL · 155 KB
- Tiny_Zipperpull_-_Cover.stl STL · 131 KB
- Tiny_Zipperpull_-_clip.stl STL · 169 KB
- Small_ZipperPull-Glued_-_clip.stl STL · 236 KB
- Small_ZipperPull-Glued_-_Cover.stl STL · 194 KB
- Categoría
- Repuestos
- Formatos
- STL
- Descargas
- 17,301
- Publicado
Sobre este modelo
Zipper pull replacement using a paperclip for a strong connection to the zipper. There are several posts inside and should fit a variety of paper clips, some bending may be required. I used 3 M2x6 screws to hold it together. update 11/2/17 Added a second smaller pull should work with a #1 paperclip and a third Tiny pull, again should work with the same #1 paperclip Update 11/25/18 Merry Christmas, I've added a glueable model, that I think works even better. Just add a couple drops of CA glue and push it together. (once it's all attached to the garment) Enjoy! Here's a link to the On-Shape drawing if you care to re-mix it.
Descripción original del autor, publicada en Thingiverse.
