Z-REX

Z-REX's (pronounced "Zee - Rex") are small, easy and fun prints of a dinosaur model... with an opening mouth / jaws and teeth that bite. No support required... just print it with at least 3 shells and 50% or more infill to make the jaws / mouth springy so they open and close. At standard scale Z-REX's are 125mm long. You can safely uniformly scale them up (as this will increase internal clearances), but scaling them down may result in the mouth / jaws not moving. Please refer to the images provided and print instructions for additional information... and post photos of your Z-REX's. Z-REX's work in the same way as my SHARKZ / CROCZ / EAGLEZ etc. These prints can be found at: 'Bugz' http://www.thingiverse.com/thing:1904654 'Sharkz': http://www.thingiverse.com/thing:910216 'Ratz' http://www.thingiverse.com/thing:1532944 'Crocz' http://www.thingiverse.com/thing:941177 'Woodpeckerz' http://www.thingiverse.com/thing:1155168 'Eaglez' http://www.thingiverse.com/thing:963892 'Catz' http://www.thingiverse.com/thing:988088 'Scorpionz' http://www.thingiverse.com/thing:1001286 Note: If you like this check out the rest of my fun and practical designs.