Yamaha right fork lug guard
por blair5032 en Printables
A guard for the bottom of Yamaha KYB dirt bike forks
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a blair5032.
Archivos (1)
- Categoría
- Jardín
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
Designed for Yamaha KYB SSS (48mm) forks. Fits on the side without the brake disk. The holes are wider than the bolts to allow for some 10mm diameter, 1mm wall steel tube to be used. It has not broken on me yet, but this should allow tension to be maintained if it did. You will need longer bolts than stock. Printed on a Bambu P2S, using PA6-GF, 100% infill and supports. Has a small amount of flex right at the back, but only when pulling from the inside out, which normally should not be an issue.
Descripción original del autor, publicada en Printables.
