XT60 Plug Housings
por Tim Krins en Thingiverse
A set of covers for a straight-through XT60 connection (mainly so I can avoid shrink tubing). Has 2 separate 4mm diameter wire holes. The fit is a bit loose but suits my requirements. I printed on a raft - without one, you may need to cut some of the inner edge to fit the connector. Note that not...
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Tim Krins.
Archivos (4)
- Categoría
- Repuestos
- Formatos
- STL, F3D
- Descargas
- 9,397
- Publicado
Sobre este modelo
A set of covers for a straight-through XT60 connection (mainly so I can avoid shrink tubing). Has 2 separate 4mm diameter wire holes. The fit is a bit loose but suits my requirements. I printed on a raft - without one, you may need to cut some of the inner edge to fit the connector. Note that not all connector brands may be the same. No supports needed. SAFETY: Please please keep in mind that you should solder your connectors really well. With these covers you won't be able to see if the wire might have come loose inside - so it is probably still safer to individually heat shrink the connections, especially if you are sending a lot of unfused current down them.
Descripción original del autor, publicada en Thingiverse.
