XT60 male mount, split clamp, M3

Two-part holder for an XT60 male connector, for building it into a case wall or panel. The connector is captured between two halves. In front, a 0.75 mm lip stops it from being pulled out, but the female plug passes through the window. A rear stop takes the push force when plugging in. The window and pocket follow the XT60 key, so the plug only goes in one way round. Two M3 screws with captive nuts clamp the halves and fix the mount to a panel at the same time. Fit: pocket 16.1 x 8.3 x 16.4 for a 15.7 x 8 x 16 XT60. Tested in PETG, 0.2 mm layer. The photos show the fit-test print; the M3 ears were added afterwards. Print both halves flat side down, no supports. Source files included: Fusion archive (.f3d) and STEP.