x56 HOTAS + Autonomous Chair
Some pressure clamping mounts I made for my x56 HOTAS and Autonomous chair. They are a little loose because the uprights taper, so there are some shims that I use included.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Phraust B.
Archivos (7)
- HOTAS_02B.stl STL · 10,4 MB
- HOTAS_02C.stl STL · 7,9 MB
- HOTAS_02SH.stl STL · 636 KB
- HOTAS_01A.stl STL · 33,0 MB
- HOTAS_01B.stl STL · 33,0 MB
- HOTAS_01C.stl STL · 13,8 MB
- HOTAS_02A.stl STL · 11,6 MB
- Categoría
- Repuestos
- Formatos
- STL
- Descargas
- 171
- Publicado
Sobre este modelo
Some pressure clamping mounts I made for my x56 HOTAS and Autonomous chair. They are a little loose because the uprights taper, so there are some shims that I use included.
Requires a total of 4 16p nails, 2 10p nails, and whatever nuts and bolts you want to use for attaching the HOTAS (I used 8x 80mm M6 screws with little knurled nuts).
The mount for the stream deck is optional (though this is why I used 80mm screws to accommodate the extra length). These parts are snap fit, but to stick the StreamDeck to the mount I used 4ea 8x3mm neodymium magnets superglued into the frame.
UPDATE Added 2x STLs for the StreamDeck mount:
HOTAS_02Av2 now has 8 total magnets for extra stickyness.
HOTAS_02Bv2 has now been lengthened by 40mm to (hopefully) clear the top of the throttle at full.
Descripción original del autor, publicada en Thangs.
