Wrench Organizers
por Domo Affogato en Thingiverse
Magnets used are 12 x 3 mm and attached using superglue (I highly recommend BSI InstaCure with accelerant). The only 2 holders in the picture not 3D printed are from Ernst (and are bigger than my print bed).
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Domo Affogato.
Archivos (8)
- Tappet_Wrench_Holder_L_v1.stl STL · 109 KB
- Offset_Wrench_Holder_Single_v2.stl STL · 156 KB
- Tappet_Wrench_Holder_R_v1.stl STL · 109 KB
- Reverse_Ratchet_Wrench_Holder_v1.stl STL · 219 KB
- Forward_Ratchet_Wrench_Holder_v1.stl STL · 219 KB
- Midget_Wrench_Holder_Single_v1.stl STL · 214 KB
- Flare_Nut_Wrench_Holder_Single_v1.stl STL · 181 KB
- Short_Wrench_Holder_Single_v1.stl STL · 211 KB
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 1,275
- Publicado
Sobre este modelo
Magnets used are 12 x 3 mm and attached using superglue (I highly recommend BSI InstaCure with accelerant). The only 2 holders in the picture not 3D printed are from Ernst (and are bigger than my print bed).
Descripción original del autor, publicada en Thingiverse.
