Wolverine Helmet Stand
Recently printed out Deadpool and Wolverine masks and needed a stand. So I put this together. You will need a 3/4 inch wood dowel cut to your preferred length.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalSin licencia indicada
El autor no indicó una licencia: todos los derechos le pertenecen. Úsalo solo para imprimir en casa y consulta al autor para cualquier otro uso.
Al descargar aceptas respetar la licencia y dar crédito a bdubil.
Archivos (4)
- top.stl STL · 55 KB
- Wol-base.stl STL · 37 KB
- Wol-plaque.stl STL · 141 KB
- base-bottom.stl STL · 12 KB
- Categoría
- Cosplay y props
- Formatos
- STL
- Descargas (todas las plataformas)
- 627
- Publicado
También en
Sobre este modelo
Recently printed out Deadpool and Wolverine masks and needed a stand. So I put this together. You will need a 3/4 inch wood dowel cut to your preferred length.
Plaque - has a notch in it so it can be glued on the base at an angle. You can also glue it facing straight up on the base if you like. I paused the print for the color change on mine. I did use supports on the notch in the plaque.
base-bottom.stl - This doesn't need to be printed unless you want the bottom covered. It is only 2mm thick so adjust the Z height in your slicer if you need it thicker.
Check my profile for the Deadpool Stand
Print Settings - Printer brand: Longer - Printer: Longer LK5 Pro - Rafts: No - Supports: Yes - Resolution: .2 - Infill: 10 - Filament brand: Esun - Filament color: Ruby Red - Filament material: PLA Notes: I printed everything but the plaque at .28 to save some time. Plaque was done at .2
Descripción original del autor, publicada en Thangs.
