Wire stripper
por Dragon FromMoscow en Thingiverse
Wire stripper. Not very beautiful (this is too big blade for this tool), but works well. All you need is M3 screw, M3 nut, and utility blade. UPDATE: Made version 2 - stronger and without useless trigger. :) I suggest to use supports while printing for M3 nut hole, but some folks says, that it...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Dragon FromMoscow.
Archivos (1)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 31,008
- Publicado
Sobre este modelo
Wire stripper. Not very beautiful (this is too big blade for this tool), but works well. All you need is M3 screw, M3 nut, and utility blade. UPDATE: Made version 2 - stronger and without useless trigger. :) I suggest to use supports while printing for M3 nut hole, but some folks says, that it prints fine without using supports. HINT: You can strip really thin wires (for example from servo motor or RC flight controller (0.8 mm in diameter with insulation)) with last third of the blade, near ring for finger.
Descripción original del autor, publicada en Thingiverse.
