Wind-up Resin Ready Brutalis Dreadnought

Pretty simple, really - I took Felix's model and modified it so I could print some brutalis, and so I am sharing it here. I made the torso weapons to be magnitized similar to OLEXANDRBODOV's redemptor torso weapons. Mine are different and not copied, just constructed very similar so as to be compatible. So you can use his stuff if you like them better. I think mine look closer to the model.

The model allows the usage of 4/5x1mm and 4/5x2mm magnets as well as 2/3x2mm for torso weapons. Some slots may fit 1mm depth better... I made the ironhail so that you can magnetize in case it gets broken. I also made the torso and pelvis linkage with a posable pelvic cap so that the torso can we glued at different angle and yet still dissembled because it just slots into the pelvis. I hollowed pieces to save weight and resin - you should clean the inside of hollow pieces really well and its a good idea to use a UV pen light to cure inside.

Mirror as needed to get the desired number of components and the right pose - use 3D builder or similar to 'dry fit'.

The legs are also made more posable to allow greater knee and ankle angles. the foot has a couple of different poses... the fist/ claws are magnetized - basically you can have the same body used for all brutalis options - just magnetize the fist/claws and torso weapons. I kept the torso generic, so add your own chapter stuff.

all parts are compatible with other kits that use the windup redemptor as a base. I included versions of the fist/ claws without digits so you can add your own.

A note on Attribution and License:

I only use components of previously published models that were published AT THE TIME OF MY DOWNLOAD under the following Licenses:

CC BY

This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator.

The license allows for commercial use.

CC BY-SA

This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator.

The license allows for commercial use. If you remix, adapt, or build upon the material, you must license the modified material under identical terms.

CC BY-NC

This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, and only so long as attribution is given to the creator.

CC BY-NC-SA

This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, and only so long as attribution is given to the creator. If you remix, adapt, or build upon the material, you must license the modified material under identical terms.

All of my stls are distributed under the CC BY-NC-SA license code.

This was mixed from the following creators - free content only, licnesed as stated above:

Felixthecrazy - main components, previously downloaded and licensed as above

CIKKIROCK - multimelta

VOID_ASSAULT - claw

LEESEDRENFORT - crow stubber barrel

VONTRAGG - vehicle hvy bolter

PLEVRAGOR - hvy bolter

CRAFTOS - contemptor fist

I tend to only use Thingiverse/Cults downloads and I always verify the license, please let me know if you have questions.