Wheel Phone Holder

⚠ Safety: This holder is for use only when the vehicle is parked. Remove it before driving: on the wheel it can block the dashboard, interfere with steering and get in the way of the airbag. Eat lunch in your car? Watch videos, take a video call or follow a recipe hands-free, with your phone right in front of you. 📱🚗 This holder hangs from the top of your steering wheel. Its center of gravity sits below the hook, so it levels itself and leans against the wheel rim, keeping your phone steady and upright in landscape. It works without screws, clamps or exact measurements: put it on and take it off with one hand. Features: - Fits almost any car: wheel rims from 28 to 42 mm thick

- Self-leveling design: hangs by gravity and keeps the phone nearly vertical on any rim size

- Phones up to 12 mm thick (including case).

- Material-saving: the diamond cut-outs remove about 17% of the volume

- Easy print: prints on its side with no supports.

Recommended print settings: - Material: PETG (strongly recommended, since PLA can warp in a hot car)

- Layer height: 0.2 mm

- Walls: 3

- Infill: 15–20%

- Supports: none (print as oriented in the file)