Weed Grinder Stand (Parametric)

Overview A simple stand for the "5 piece Ongrok Toothless Herb Grinder with Storage" that I made to hold: - The grinder itself

- The little pieces it comes with (guitar pick and brush)

- A paper straw for packing the weed into a joint (it fits the one I found in the package for the cones)

Parameterization It I also made it parametric, so it could theoretically hold other grinders if you wanted to give it a try (untested as I only have the 1 grinder). By default, the main settings are: - Fitment padding: 0.4mm

- Grinder - Diameter: 54.4mm

- Fitment padding applies

- Brush - Width: 11.25mm

- Thickness: 2.5mm

- Fitment padding applies

- Pick - Thickness: 0.75mm

- Pick width 20mm up from the point: 25mm

- Fitment padding applies only to the thickness

- Packer (straw) - Diameter: 6.1mm

- Fitment padding does not apply

Print Settings It doesn't really need to be strong, so any print setting is probably fine. I printed it using 3DPrintingCanada's PLA+, and I had 15% gyroid infill. Versions Version Notes

v6 - Added a spot for a straw. I originally didn't have this since it was originally just intended to hold the parts that came with the grinder itself, but I quickly realized that it made sense to keep it all together (and there was free space beside where I had the brush).

- Shaped the slot for the guitar pick to roughly match the contour of the pick so that it stands up properly and doesn't fall to one side.

v5 Initial release.