Wearable HellDivers Helm
por vinnybagadonutz en Printables
Hell Divers 2 helm. Model acquired from @AverageArmad_1033996. cleaned up/Scaled up to fit my head for a cosplay.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a vinnybagadonutz.
Archivos (20)
- Full.stl STL · 1,5 MB
- leftTop.stl STL · 52 KB
- rightTop.stl STL · 52 KB
- left.stl STL · 368 KB
- TopMid.stl STL · 78 KB
- mask.stl STL · 520 KB
- rear.stl STL · 342 KB
- right.stl STL · 371 KB
- Adjusted_Helm.3mf 3MF · 783 KB
- visR.stl STL · 30 KB
- right top.stl STL · 51 KB
- mid top.stl STL · 68 KB
- mask.stl STL · 502 KB
- left top.stl STL · 52 KB
- visL.stl STL · 39 KB
- right.stl STL · 369 KB
- rear.stl STL · 355 KB
- left.stl STL · 364 KB
- hell diver helm.3mf 3MF · 1,0 MB
- full_Helm.stl STL · 1,5 MB
- Categoría
- Cosplay y props
- Formatos
- STL, 3MF
- Descargas
- 2,777
- Publicado
Sobre este modelo
The Model is scaled to MY head. You will need to make your own measurements and scale it to yours. I have a big head so you have been warned.
The parts have non manifold edges you will have to right click them and repair them in the slicer.
I'll probably fix them up later but until then just fix them in the slicer.
Print with supports.
I used blender to cut the parts up so it's a little rough but it will work for my purposes.
Update---------------------------
Made helm smaller as it was wayyyyyyyyyyyyyyyyyyyyyyyyyyyy too big. whoops
Descripción original del autor, publicada en Printables.
