WATER GRENADE
por AFO3D en MakerWorld
Pull the pin and throw them fast, they will explode!! Transform your Water Balloons in Water Grenades
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a AFO3D.
Archivos (3)
- BODY.stl STL · 1,3 MB
- LATCH.stl STL · 1,4 MB
- PIN.stl STL · 2,6 MB
- Categoría
- Jardín
- Formatos
- STL
- Descargas
- 5,399
- Publicado
Sobre este modelo
Pull the pin and throw them fast, they will explode!! Transform your Water Balloons in Water Grenades Share your prints!!
INSTRUCTIONS: Intoduce the tip of the balloon and clip it in, then secure it with the pin.
You can use a spring from any kind of pen to make the latch fly off when thrown and to ensure the balloon is released. MAX spring diameter 5mm (Maybe you will need to cut the spring to length)
Follow me on: Instagram: https://www.instagram.com/afo3d/ TikTok: https://www.tiktok.com/@afo3d Youtube: https://www.youtube.com/@AFO3D
Licensing All my designs are non-commercial and may not be sold, reproduced, or shared outside of this website. If you wish to sell any of them you must subscribe to my Thangs.com or Printables.com Commercial membership plans.
Reccomended Print Settings:
- Support
- Brim
- 0.2mm layer height
-AFO
Descripción original del autor, publicada en MakerWorld.
