Wall hook for extra heavy cane (1" shaft)
por Andy Holzrichter en Thingiverse
I'm printing mine on it's back w/ 4 walls 4 top 4 bottom in PETG (because it's what I normally use). Hanging it w/ sheetrock screws. In my case 1 1/4 or 1 1/2 should allow it to reach a stud and make it secure. I designed this for an extra heavy cane from Purpleheart Armory.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Andy Holzrichter.
Archivos (1)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
I'm printing mine on it's back w/ 4 walls 4 top 4 bottom in PETG (because it's what I normally use). Hanging it w/ sheetrock screws. In my case 1 1/4 or 1 1/2 should allow it to reach a stud and make it secure. I designed this for an extra heavy cane from Purpleheart Armory.
Descripción original del autor, publicada en Thingiverse.
