Very Small picture frame clamps.
por Rahman Sattaur en Thingiverse
Used to square-up a very small frame or box. Outside measurement is 20 mm X 20 mm while the inside is 10 mm X 10 mm one hole is threaded with m 3 X 0.35 for a threaded 3 mm rod (Length is sized to your project). I used knurled nuts on the threaded rods. You will need at least four of these. along...
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Rahman Sattaur.
Archivos (1)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
Used to square-up a very small frame or box. Outside measurement is 20 mm X 20 mm while the inside is 10 mm X 10 mm one hole is threaded with m 3 X 0.35 for a threaded 3 mm rod (Length is sized to your project). I used knurled nuts on the threaded rods. You will need at least four of these. along with 4 threaded 3 mm rods to your required length and 4 nuts to tighten the clamp.
Descripción original del autor, publicada en Thingiverse.
