Vented U1 toolhead top
por Aaron Trag en Printables
This version it taller and has side vents optisit the tension arm and over the extruder motor.
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Aaron Trag.
- Categoría
- Para tu impresora
- Formatos
- STEP, STL
- Descargas
- 0
- Publicado
Sobre este modelo
I had a few times of getting over temp errors after printing that were from the toolhead boards while printing with polycarbonate and high temp breakaway filament. This adds 2 vents and a talled driver board enclosure to allow the heat to disipate better. Because of the chamber temps as well as being directly over the toolhead and near the extruder motor, this really needs to be printer in polycarbonate. You could try PCTG, but I would be concerned with that if you are then printing polycarbonate.
Descripción original del autor, publicada en Printables.
