Vase mode Christmas tree baubles
por Jane Rain en Thingiverse
Set of Christmas baubles, printed in vase mode, no infill. Add brim or watch out for model fall. I printed without brim.There is a version with no hole to glue the topper attached on, and second with hole for hanging already there. You can add some bell clapper for fun (some bead on thread), there..
Licencia
Solo uso personalCC BY-NC-ND 4.0 — Atribución, no comercial, sin derivadas
Solo para uso personal, sin modificarlo y dando crédito. No se permite vender ni redistribuir cambios.
Al descargar aceptas respetar la licencia y dar crédito a Jane Rain.
Archivos (14)
- Christmas_-_Ozdobicky.rar RAR · 10,8 MB
- settings.txt TXT · 1 KB
- sharp_withhole.stl STL · 328 KB
- bell_withhole.stl STL · 1,5 MB
- onion_withhole.stl STL · 1,4 MB
- bulb_sharp.stl STL · 311 KB
- smallbulb_withhole.stl STL · 1,8 MB
- bulb_small.stl STL · 264 KB
- bulb_bell.stl STL · 1,5 MB
- bigbulb_withhole.stl STL · 1,8 MB
- bulb_top.stl STL · 804 KB
- bulb1big.stl STL · 1,8 MB
- bulb_onion.stl STL · 1,4 MB
- bell_without_tophole.stl STL · 1,4 MB
- Categoría
- Hogar
- Formatos
- RAR, TXT, STL
- Descargas
- 42,869
- Publicado
Sobre este modelo
Set of Christmas baubles, printed in vase mode, no infill. Add brim or watch out for model fall. I printed without brim.There is a version with no hole to glue the topper attached on, and second with hole for hanging already there. You can add some bell clapper for fun (some bead on thread), there is a hole for that prepared.
Descripción original del autor, publicada en Thingiverse.
