Valve stem cap w/ a D
por S R en MyMiniFactory
In my slicer (Slic3r) it works, but i'm not sure it if will work for others. if your slicer shows the bottom layer as solid (no hole to screw on) try cutting off the bottom few layers in your slicer
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a S R.
Archivos (3)
- Categoría
- Educación
- Formatos
- STL
- Descargas
- 10,075
- Publicado
Sobre este modelo
In my slicer (Slic3r) it works, but i'm not sure it if will work for others. if your slicer shows the bottom layer as solid (no hole to screw on) try cutting off the bottom few layers in your slicer
I printed 2 shorter ones, one with a slight curve because why not
the 2 example gray short ones were printed with .2mm layers and the pink one was .15mm
the shorter ones don't print perfectly and sometimes you have to reload them in your slicer to make them print correctly, just print them in black and who the hell cares am I right?
Descripción original del autor, publicada en MyMiniFactory.
